What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 23:59
He then describes the function of a fuse.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
There are three different concepts here that are getting confused.
How and why do cats purr? Scientists finally found the answers - Earth.com
One
2024–10–16 [ OO OLAOYE OYEBODE ]
There are two important concepts here.
WWDC 2025: iOS 26 Rumored Features - MacRumors
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–10[John johnson John Johnson ]
[old diagram got deleted by accident]
I Discovered I Got Cheated On. But His Story About That Night Isn’t Adding Up. - Slate Magazine
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
At one ohm, the resistor has a maximum of 1 watt power.
First Sentence:
Now when you have a certain ac resistance, then a current flows in a loop.
Barnstars:
So, the voltage could go up to 500 volts, and the fuse will not open up.
What is lightning?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
How Moderna Went From Pandemic Hero to Vaccine Victim - WSJ
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
These devices are installed between the “hot” and “neutral” and protective ground.
what exactly is a ‘surge’ protector?
Live Updates From Apple WWDC 2025 🔴 - Gizmodo
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Edit 2024–10.
This device then solves the entire problem.
Molly Jong-Fast on Human Frailty and Unlearning Erica Jong’s Lessons - Literary Hub
but this device (an Inductor) … impedes the rapid changes in the current.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
but I think this circuit , shows a few more pieces.
Feature: 11 Games With 'Secret' Performance Bumps You Should Revisit On Switch 2 - Nintendo Life
A fuse is a non-resetable over current circuit protector.
The bolt then partially travels down the line to your home.
It also is a device that limits the change in current flow.
ChatGPT wasn’t built for this, but it’s now the center of my daily routine - Android Authority
In schematic diagrams this is the symbol for a fuse:
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
He then describes Rainy Season and Lightning.
Pokémon developer Game Freak reveals Beast of Reincarnation at Xbox Games Showcase - Eurogamer
The third is lightning and “how it gets conducted into a home.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
the problem then depends on "how fast does the fuse operate?".
Where you live may affect your risk of dementia, UCSF study finds - San Francisco Chronicle
A circuit breaker is similar, but is resettable.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
For this case there are devices called Metal oxide varistors (MOV).
What are the extra benefits of a smart TV?
Because the load is inductive, the current lags the voltage.(by a bit).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
An AC voltage/ current source, and an ac inductive load.
This is 'the assistant's answer'
nine
so, what happens?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This one hit behind the barn.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
What does a fuse do?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
One is “what exactly is in a ‘surge protector’ ? ”
I post the exact comment here.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
(Dc diagram shown, AC is similar).
This is where the MOV conducts again, and dissipated the energy.
[image of Common-mode choke]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
It seems Mohan does not understand the difference between a comment and an Answer.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
But it can get overloaded, and no longer works.
Upvotes:
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
The other is “what does a “fuse” do?”
But… the neutral is now “floating” because of the 1 ohm resistance.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
2024–10–14 [Omar Gharbi Omar Gharbi ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
eight
He then asserts :
Here is a simplified AC power diagram.
At least they know the answer if they wanted it.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
These are simplified answers to the original question, and does not change anything I wrote above.
a photo is worth a thousand words.
The MOV will conduct when the voltage exceeds 50% of line voltage.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Can the fuse protect the electronic devices from lightning instead of a surge protector.